Remove and replace the Bob-Tach stop (Item 1) [Figure 50-41-12] (both sides) if worn or damaged. NOTE: The Bob-Tach stop (Item 1) [Figure 50-41-12] must…

Use the following procedure to remove and install the Bob-Tach lever (Item 1) [Figure 50-41-6], spring and wedge. Use a punch and hammer, remove the…

Tilt the Bob-Tach forward, so it is parallel to the floor. Put blocks (approximately 3 inches) under each side of the Bob-Tach [Figure 50-41-1]. Lower…

The Bob-tach is the section of the loader lift arm that attachments mount to. The Power Bob-tach option uses two hydraulically operated, spring assisted, locking…

Remove the Bob-Tach. (See Removal And Installation on Page 50-40-1.) Remove the rubber seal (Item 1) [Figure 50-40-15]. Installation: Use a new seal when assembling.…

Remove and replace the Bob-Tach stop (Item 1) [Figure 50-40-14] (both sides) if worn or damaged. NOTE: The Bob-Tach stop (Item 1) [Figure 50-40-14] must…

Use the following procedure to remove and install the Bob-Tach lever (Item 1) [Figure 50-40-8], spring and wedge. Remove the lever mounting bolt and nut…

Tilt the Bob-Tach forward, so it is parallel to the floor. Put blocks (Item 1) [Figure 50-40-1] approximately 3 inches thick under each side of…

The Bob-Tach is the section of the loader lift arm that attachments mount to. The Bob-Tach uses two manually operated, spring assisted, locking wedge and…

Raise the operator cab. (See Raising on Page 10-30-2.) Remove the operator seat. (See Removal And Installation on Page 50-31-1.) Remove the mounting nut (Item…