The steering system [Figure 50-100-1] consists of independent steering levers the operator uses to provide steering input to the loader. The steering levers are attached…

Remove the bolt (Item 1) holding the linkage (Item 2) [Figure 50-91-7] to the side of the foot pedal. Remove the spacer (Item 1), linkage…

Remove the pin (Item 1) [Figure 50-91-5] holding the linkage to the sensor. Tip the foot pedal up and remove the two nuts (Item 1)…

Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Raise the operator cab.(See Raising on Page 10-30-2.)…

The control pedals send an electronic pulse to the actuators on the control valve. The electronic pulse tells the actuators to move the lift or…

After installing the pedal, adjust the pedal angle so that there is clearance under the rear of the pedal. The valve spool must travel full…

Remove the crossbar pivot bolt and washer (Item 1) [Figure 50-90-3]. Remove the bolt, washer and nut (Item 1) [Figure 50-90-4] to disconnect the lift…

Raise the lift arms and install an approved lift arm support device.(See Installing on Page 10-20-1.) Raise the operator cab.(See Raising on Page 10-30-2.) Remove…

The control pedals and linkages are connected to the control valve. The control pedals will mechanically move the lift and tilt spools on the control…

Disconnect the fuel fill hose (Item 1) [Figure 50-80-7] from the fuel tank. Remove the fuel inlet screen (Item 1) [Figure 50-80-8]. Clean and dry…