Raise the lift arms and install an approved lift arm support device.(See Installing on Page 10-20-1.)
Raise the operator cab.(See Raising on Page 10-30-2.)
Remove the bolt (Item 1) [Figure 50-90-1] and nut from the pedal linkage.
Installation: Tighten the bolt and nut to 25 – 28 ft.-lb. (34 – 38 Nโขm) torque.
Check the rubber bushing in the pedal for wear and replace as needed.
Remove the two mounting bolts (Item 1) [Figure 50-90-2] from the pedal mounting bracket.
Remove the pedal assembly from the loader.
