Lower the work group to the ground. Stop the engine. With the engine off, turn the start key to the ON position and move both…

Clean the outside of the hydraulic X-Change manifold before disassembly. Remove the nut (Item 1) [Figure 20-210-4]. Remove the two solenoids (Item 1) [Figure 20-210-5].…

Lower the work group to the ground. With the engine off, turn the key to the ON position and move both hydraulic control levers to…

Open the right side cover. Install a female quick coupler and hose on the male quick coupler (Item 1) [Figure 20-200-1]. Remove the fill cap…

Remove the bolts (Item 1) [Figure 20-190-3] and nuts. Remove the valve from the floor pan. Installation: Tighten the bolts to 43 – 47 N•m…

Remove the travel levers. (See Removal And Installation on Page 40-100-1.) Remove the floor mat and center floor plate. (See Removal And Installation on Page…

Remove the floor mat and center floor plate. (See Removal And Installation on Page 40-110-1.) Remove the bolts (Item 1) [Figure 20-180-1]. Tip the filter…

Remove the connector lock (Item 1) [Figure 20-170-15]. Depress the wire terminal tabs and remove the wires from the back of the electrical connector [Figure…