BobCat 753 – HYDRAULIC CONTROL VALVE (FOOT CONTROL) – Auxiliary Spool Removal And Installation

Remove the screws (Item 1) [Figure 20-40-114] from the end cap (both sides).

Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque.

Remove the end cap, O-ring, springs and washer, (both sides) [Figure 20-40-115].

Remove the spool [Figure 20-40-115].

Assembly: Put grease on all the centering spring component parts. Always use a new spool seal.