Raise the loader operator cab. (See Raising The Operator Cab on Page 10-30-1.)
Remove the two mounting bolts (Item 1) [Figure 40-10-5] from the brake pedal mounting bracket.
Disconnect the electrical connector from the parking brake pedal sensor. The connector is located behind the control panel.
Installation: Tighten the mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.
Remove the fuse mount bracket (Item 1) [Figure 40-10-6] from the front of the control panel.
Remove the parking brake assembly from the loader.
Reverse the removal procedure to install the parking brake assembly in the loader.
