Stop the engine and open the rear door.
Remove the rear grill. (See Removal And Installation on Page 50-60-1.)
Remove the oil cooler. (See Removal and Installation on Page 20-100-1.)
Loosen the radiator cap (Item 1) [Figure 70-50-1] from the pressurized expansion tank.
Open the drain valve (Item 1) [Figure 70-50-2] on the engine block and drain the coolant into a container.
Loosen the hose clamp (Item 1) [Figure 70-50-3] from the left side radiator hose and disconnect the hose from the radiator.
Remove the radiator mounting bolt (Item 2) [Figure 70-50-3].
Installation: Tighten the radiator mounting bolt to 11 – 13 ft.lb. (15 – 17 Nโขm) torque.
Loosen the hose clamp (Item 1) [Figure 70-50-4] from the left side radiator hose and disconnect the hose from the radiator.
Remove the radiator mounting bolt (Item 1) and block off plate (Item 2) [Figure 70-50-5].
Installation: Tighten the radiator mounting bolt to 11 – 13 ft.-lb. (15 – 17 Nโขm) torque. Use sealant on the block off plate and bolt head (Item 2) [Figure 70-50-5].
Remove the two rubber stops (Item 1) [Figure 70-50-6] & [Figure 70-50-7] from the top of the radiator.
Disconnect the overflow hose (Item 2) [Figure 70-50-6] & [Figure 70-50-7].
Lift the radiator (Item 3) [Figure 70-50-7] up and remove from the machine.
