Raise the loader lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)
Raise the loader operator cab. (See Raising on Page 10-30-2.)
Disconnect the front steering linkage bars from the rear linkage bars. (See Removal and Installation on Page 50-100-2.)
Move the linkage bars to allow adequate space to remove the rear chaincase cover.
Remove the rear chaincase cover mounting screws (Item 1) [Figure 40-30-3].
Remove the rear chaincase cover (Item 2) [Figure 40-30-3].
NOTE: There are machined recesses (Item 3) [Figure 40-30-3] on the bottom side of the cover to help pry the covers off.
Installation: Apply polyurethane sealer to mating surfaces. Polyurethane sealant should be applied to the screw threads to stop oil leakage. Tighten the mounting screws to 20 – 25 ft.-lb. (27 – 34 Nโขm) torque.
