Remove the snap ring (Item 1) [Figure 20-80-7].
Remove the nylon ring (Item 1) [Figure 20-80-8].
Tap the rotor (Item 1) [Figure 20-80-9] out of the housing.
Continue to remove the rotor (Item 1) [Figure 20-80-10] until the rotor is out of the housing.
Remove the crown seals (Item 1) and remove the seals (Item 2) [Figure 20-80-11].
Assembly: Heat the crown seals and seals in hydraulic oil for three minutes at 54ยฐC (130ยฐF) before installing the seals on the rotor.
