BobCat E35 – SWING MOTOR – Removal And Installation

Drain the hydraulic reservoir. (See Removing And Replacing Hydraulic Fluid on Page 10-130-5.)

Remove the floor mat. (See Removal And Installation on Page 40-110-1.)

Remove the tool box. (See Removal And Installation on Page 40-230-1.)

Remove the hoses from the swing motor [Figure 20-90-1].

Remove the counterbalance valves (Item 1) [Figure 20-90-2].

Remove the six bolts (Item 1) [Figure 20-90-3].

Installation: Tighten the bolts to 35 – 39 Nโ€ขm (25.5 – 28.5 ft-lb) torque.

Remove the swing motor. Remove the O-ring (Item 1) [Figure 20-90-4] from the swing motor drive carrier.