Remove the left handle. (See Handle Removal And Installation on Page 20-120-2.)
Clean the outside of the control lever before disassembly.
Remove the boot (Item 1) [Figure 20-120-14].
Mark the coupler (Item 1), nut (Item 2), and connector (Item 3) [Figure 20-120-15] for ease of assembly.
Loosen the nut (Item 1) and remove the connector (Item 2) [Figure 20-120-16].
Mark the coupler (Item 1), control plate (Item 2), and plate (Item 3) [Figure 20-120-17] for ease of assembly.
Remove the coupler (Item 1) from the control plate (Item 2) [Figure 20-120-18].
Remove the control plate (Item 1) from the U-joint (Item 2) [Figure 20-120-19].
Mark the plate and housing for correct installation.
Remove the U-joint (Item 1) [Figure 20-120-20].
NOTE: The plate (Item 2) [Figure 20-120-20] is spring loaded and will come up as the U-joint is removed.
Remove the plate (Item 1) [Figure 20-120-21].
Remove the plunger assemblies (Item 1) [Figure 20-120-22].
Remove the O-rings (Item 1) and plunger (Item 2) from the bushing (Item 3) [Figure 20-120-23].
Remove the spool assemblies (Item 1) [Figure 20-120-24].
Compress the spring (Item 1) and remove the seat (Item 2) [Figure 20-120-25].
Remove the spring (Item 1) and shim (Item 2) from the spool (Item 3) [Figure 20-120-26].
Remove the springs (Item 1) [Figure 20-120-27] from the housing.
Clamp the housing in a vise that is equipped with padded jaws [Figure 20-120-28].
Remove the two bolts (Item 1) [Figure 20-120-28].
Remove the end cap (Item 1) [Figure 20-120-29].
Remove the O-ring (Item 1) and seal (Item 2) [Figure 20-120-30].
