Remove the plug (Item 1) [Figure 20-40-78].
Installation: Tighten the plug to 69 – 78 Nโขm (51 – 58 ft-lb) torque.
Remove the spring (Item 1) and compensator valve (Item 2). Remove the O-ring (Item 3) [Figure 20-40-79].
NOTE: The compensator valve must be installed in the valve section it was removed from.
Installing the incorrect compensator valve will cause poor hydraulic valve performance.
Remove the screws (Item 1) from both end caps.
Remove the end caps (Item 2) [Figure 20-40-80].
Installation: Tighten the screws to 7,5 Nโขm (5.5 ft-lb) torque.
Remove the O-ring (Item 1), spring seat (Item 2), spring (Item 3) and spring seat (Item 4) from both ends of the valve. Remove the spool (Item 5) [Figure 20-40-81].
NOTE: The spool is not symmetrical. Incorrect spool installation will cause poor hydraulic valve performance.
Remove the orifice (Item 1) [Figure 20-40-82].
Installation: Tighten the orifice to 7,5 Nโขm (5.5 ft-lb) torque.
