Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)
Remove the four seat mounting nuts (Item 1) [Figure 50-31-1] and washers from the operator seat mounting studs.
Installation: Tighten the mounting nuts to 20 ft.-lbs. (27 Nm) torque.
Lower the cab and install one of the mounting washers and nuts [Figure 50-31-2].
NOTE: With the seat removed the cab will raise.
Reverse the removal procedure to install the operator seat.
NOTE: Assure seat tethers are securely fastened to seat belt studs (Item 1) and seat rail studs (Item 2) [Figure 50-31-3].
NOTE: Verify the front two seat rail studs have washers attached (Item 1) [Figure 50-31-4].
