Stop the engine. Open the rear door.
Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)
Remove the negative (-) cable from the battery. The battery may be removed for additional working clearance.
(See Removal And Installation on Page 60-20-1.)
Remove the belt shield [Figure 30-50-6]. (See Shield Removal And Installation on Page 30-50-1.)
Remove the fan drive belt (Item 1) [Figure 30-50-7].
The belt tensioner is located between the flywheel and pump pulley. Loosen and remove the bolt (Item 2)
[Figure 30-50-7] from the belt tensioner.
Remove the belt tensioner assembly.
Remove the drive belt from the pump pulley and flywheel.
Remove the drive belt from the loader [Figure 30-50-8].
Install the new drive belt. Install the belt tensioner assembly.
Install the fan drive belt.
Adjust the drive belt. (See Adjusting on Page 30-50-1.)
Reinstall belt shield and connect the negative (-) cable to the battery.
