BobCat 753 – CONTROL HANDLE (ADVANCED HAND CONTROL) (AHC) W/PUSH BUTTON FLOAT – Handle Sensor Removal And Installation

To remove the handle sensor, slide the rubber handle cover (Item 1) [Figure 50-112-3] up the handle.

Disconnect the loader control harness (Item 1) [Figure 50-112-4] from the handle control harness.

Using a small screwdriver remove the handle control electrical connector from the clip (Item 1) by pushing the
connector down out of the connector clip (Item 2) [Figure 50-112-5].

Using an allen wrench, remove one of the two mounting screws (Item 1) [Figure 50-112-6] from the handle
sensor.

Installation: Tighten the handle sensor mounting screws to 85 in.-lbs. (9,6 Nm) torque.

Remove the spacers (Item 1) [Figure 50-112-7] & [Figure 50-112-8].

Remove the mounting bolt and nut (Item 1) [Figure 50-112-9] from the control handle and shaft.

Remove the handle sensor (Item 2) [Figure 50-112-9] from the control handle.

Installation: Tighten the mounting bolt to 35 in.-lbs (3,9 Nm) torque.

NOTE: The handle sensor (Item 1) [Figure 50-112-10] can only be replaced as a complete assembly.

Check the spacer (Item 2) and screws (Item 3) [Figure 50-112-10] and replace as needed.