Remove the handle sensor (Item 1) [Figure 50-114-15].
(See Handle Sensor Connector on Page 60-123-5.)
Remove the switch handle (Item 1) [Figure 50-114-16].
(See Switch Handle Removal on Page 60-123-6.)
Remove the rubber handle cover (Item 1) [Figure 50-114-17] from the handle.
Using a small screwdriver, hold the handle spacer (Item 1) and remove the allen head screws (Item 2) [Figure 50-
114-18] from the handle assembly.
Installation: Tighten the allen head screws to 35 in.-lbs.(4 Nm) torque.
