Remove the lift and tilt lock block [Figure 20-40-40].
Author: MD
Remove the two screws (Item 1) [Figure 20-40-38] from the rubber boot retainer. Assembly: Tighten the screws to 90-100 ft.-lb. (10,2-11,3 Nโขm) torque. Remove the…
Remove the Anti Cavitation/Check valve (Item 1) [Figure 20-40-34] from the tilt cylinder base end port. Remove the O-rings (Item 1), and back-up washer (Item…
Remove the Port Relief/Anti Cavitation valve (Item 1) [Figure 20-40-32]. Assembly: Always use new O-rings and back-up washers. Tighten to 35-40 ft.-lb. (47-54 Nโขm) torque.…
NOTE: The main relief valve is non-adjustable. Remove the main relief valve adapter fitting (Item 1) [Figure 20-40-29]. Remove the O-ring from the main relief…
Remove the BICSTM valve assembly from the control valve. (See BICSTM Valve Removal And Installation on Page 20-40-1.) Remove and discard the four large O-rings…
See Identification Chart on Page 20-40-8 for the control valve parts assembly. Mark each valve section and spool so that the parts will be returned…
Install jackstands under the rear corners of the loader. (See Procedure on Page 10-10-1.) Raise the operator cab. (See Raising on Page 10-30-1.) Remove the…