Disconnect the wire harness (Item 1) [Figure 50-50-4]. Remove the nut (Item 1) and bolt (Item 2). Remove the boom light (Item 3) [Figure 50-50-5]…

To remove the upperstructure light, pivot the light (Item 1) [Figure 50-50-1] back inside the frame. Disconnect the wire harness (Item 1) [Figure 50-50-2]. Remove…

Disconnect the negative (-) cable from the battery. (See Removal And Installation on Page 50-20-2.) Disconnect the wires (Item 1) [Figure 50-40-3] from the starter.…

The key switch must be in the OFF position. The battery must be at full charge. The cable connections on the battery must be clean…

Open the tailgate. Remove the belt (Item 1) [Figure 50-30-7] from the engine. (See Belt Replacement on Page 50-30-1.) Disconnect the wire harness (Item 1)…

Turn the engine OFF and remove the L & S Terminal connector (Item 1) [Figure 50-30-5] from the alternator. Check the continuity between the “S”…

Turn engine OFF and remove the L & S terminal connector (Item 1) [Figure 50-30-3] from the alternator. Turn the key to the ON position.…

Open the tailgate. Start the engine and run at low idle. With a voltmeter, check the voltage between the B+ terminal and ground at the…