Remove the handle sleeve (Item 1) and bushings (Item 2) [Figure 50-113-19] from the handle. Check all parts for wear and replace as needed. Check…

Remove the handle sensor (Item 1) [Figure 50-113-15]. (See Handle Sensor Removal And Installation on Page 50-113-1.) Remove the switch handle (Item 1) [Figure 50-113-16].…

Remove one of the two mounting screws (Item 1) [Figure 50-113-12] from the handle sensor. Installation: Tighten bolt to 32-38 in.-lbs. (3,6-4,3 Nm) torque. Remove…

Remove the mounting bolt and nut (Item 1) [Figure 50-113-10] from the control handle and shaft. NOTE: Be careful not to loose the recessed nut…

To remove the handle sensor, slide the rubber handle cover (Item 1) [Figure 50-113-3] up the handle. Disconnect the loader control harness (Item 1) [Figure…

Control Handle (Item 1) [Figure 50-113-1]. Handle Sensor (Item 1) [Figure 50-113-2]. NOTE: The calibration procedure must be followed when replacing handle sensor, foot pedal…

To replace the rubber boot (Item 1) [Figure 50-112-21] on the control panel, remove the control lever. (See Control Lever Removal And Installation on Page…

Disconnect the electrical connectors (Item 1) [Figure 50-112-17] from the control lever switch handle. Remove the electrical connectors from the control lever switch handle. (See…

Remove the handle sleeve (Item 1) and bushings (Item 2) [Figure 50-112-15] from the handle. Check all parts for wear and replace as needed. Check…

Remove the handle sensor (Item 1) [Figure 50-112-11]. (See Handle Sensor Removal And Installation on Page 50-112-1.) Remove the switch handle (Item 1) [Figure 50-112-12].…