Remove the mounting nut (Item 1) [Figure 20-40-13] from the solenoid stem.
Installation: Tighten the nut to 53 in.-lb. (6 Nโขm) torque.
Remove the coil.
Remove the O-rings (Item 1) [Figure 20-40-14] from both ends of the coil.
Remove the solenoid stem (Item 1) [Figure 20-40-15].
Installation: Tighten the solenoid stem to 22 ft.-lb. (29.8 Nโขm) torque.
Remove the O-rings (Item 1) and back-up washers (Item 2) [Figure 20-40-16] from the solenoid stem.
Clean the solenoid stem in solvent and dry with compressed air.
Inspect the solenoid stem for wear and replace if it is showing excessive wear.
NOTE: The screen (Item 3) [Figure 20-40-16] may be cleaned with solvent. If it is torn or worn
replace the solenoid stem.
Apply oil to the new O-rings and back-up washers and install on the solenoid stem.
