Remove the screws (Item 1) and rubber boot (Item 2) [Figure 20-40-69] from the linkage end of the control valve.
Remove the spool seal retainer (Item 3), and O-ring (Item 4) [Figure 20-40-69] from the control valve.
Assembly: Tighten the screws to 90-100 in.-lb. (10,2-11,3 Nโขm) torque.
Remove the two mounting screws (Item 1) and detent cap (Item 2) [Figure 20-40-70].
Remove the centering spring assembly (Item 1), detent retainer (Item 2), housing (Item 3), seal retainer (Item 4), and spool seal (Item 5) [Figure 20-40-71].
