Remove the attachment. Tilt the Bob-Tach fully forward until it rests on the floor. Stop the engine. Raise the seat bar.
Engage the parking brake.
Remove the bolt (Item 1) and the retainer (Item 2) [Figure 20-21-2] from the Bob-Tach and tilt cylinder rod end pivot pin.
Installation: Tighten the bolt to 18-20 ft.-lb. (24-27 Nโขm) torque.
Remove the pivot pin from the Bob-Tach.
Remove the hoses (Item 1) [Figure 20-21-3] from the tilt cylinder fittings.
Remove the bolt (Item 1) and the retainer (Item 2) [Figure 20-21-4] from the base end of the tilt cylinder.
Remove the pivot pin (Item 1) [Figure 20-21-5] from the tilt cylinder base end and the lift arm frame.
