Clean the area before installing the rubber molding.
Install the rubber molding (Item 1) [Figure 50-120-2] around the edge of the rear opening in the operator cab.
If replacing the rubber molding (Item 1) [Figure 50-120-2] cut off the excess molding.
Apply liquid soap on the rubber cord to make installation easier. Install the rubber cord (Item 1) [Figure 50-120-3] into the molding on the inside of the operator cab.
Install the safety tag in the top center of the cord.
Apply liquid soap in the rubber molding (Item 1) [Figure 50-120-4] to make installation easier.
Install the window from the outside of the operator cab.
Install a lower corner of the rear window into the corner of the molding. [Figure 50-120-4].
Align the other lower corner of the window in the molding.
Work the window downward until the window is fully seated in the lower portion of the molding.
Use a plastic stick (Item 1) [Figure 50-120-5] under the molding lip to guide the window into the molding groove.
Use the plastic stick (Item 1) [Figure 50-120-6] to position the locking tab into the groove to secure the window in the molding.
Tapping the window corners will help seat the window in the molding.
