Remove the seat bar (Item 1) [Figure 60-110-5] from the loader. (See Removal And Installation on Page 50-10-1.)
Remove the mounting bolt (Item 1) from the seat bar mount (Item 2) [Figure 60-110-6].
Installation: Tighten the mounting bolt to 50 – 70 in.-lb.(5,6 – 7,9 Nโขm) torque.
Remove the sensor mounting bolt (Item 3) [Figure 60-110-6] and nut.
Remove the keyed plastic bushing (Item 1) magnetic bushing assembly (Item 2) and sensor bracket (Item 3) [Figure 60-110-7].
Installation: Be sure the tabs on the pivot bushing are positioned in the slotted hole (Item 1) [Figure 60-110-7] of the seat bar.
Inspect all parts for damage and wear and replace if necessary.
Reverse the removal procedure to install the seat bar sensor.
