Disconnect the light harness connector (Item 1) [Figure 50-70-1] from the engine harness.
Remove both rear lights (Item 2) [Figure 50-70-1] from the door. (See Rear Removal And Installation on Page 60-60-2.)
Secure the chain hooks (Item 1) [Figure 50-70-2] to the door as shown.
Connect a chain hoist (Item 2) [Figure 50-70-2] to the lifting chain.
Remove the top and bottom door hinge mounting bolts (Item 1) [Figure 50-70-3] and nuts.
NOTE: Install the door stop (Item 2) and the door stop retainer (Item 3) [Figure 50-70-3] in the top hinge as shown.
Installation: Tighten the mounting bolts and nuts to 25 – 28 ft.-lb. (34 – 38 Nโขm) torque.
Lift the door away from the loader frame and put the door flat on the floor.
Reverse the removal procedure to install the rear door.
