BOBCAT S130 – OPERATOR SEAT (SUSPENSION) – Removal And Installation

Raise the operator cab. (See Raising on Page 10-30-2.)

Remove the four seat mounting nuts (Item 1) [Figure 50-31-1] and washers from the operator seat mounting studs.

Installation: Tighten the mounting nuts to 20 ft.-lb. (27 Nโ€ขm) torque.

Lower the cab and install one of the mounting washers and a nut [Figure 50-31-2].

NOTE: With the seat removed, the cab will raise.

Reverse the removal procedure to install the operator seat.

NOTE: Assure seat tethers are securely fastened to seatbelt studs (Item 1) and seat rail studs (Item 2) [Figure 50-31-3].

NOTE: Verify the front two seat rail studs have washers attached (Item 1) [Figure 50-31-4].