BOBCAT S130 – OPERATOR CAB – Gas Cylinder Removal And Installation

Remove the operator cab stop (Item 1) (both sides) [Figure 50-20-1].

Remove the cab nut and holddown plate (Item 1) [Figure 50-20-2] (both sides).

Installation: Tighten the nut to 40 – 50 ft.-lb. (54 – 68 Nโ€ขm) torque.

Install a strap (Item 1) [Figure 50-20-3] to the cab handles to prevent the cab from falling forward.

Raise the operator cab. (See Raising on Page 10-30-2.), to release the tension on the gas cylinder.

Loosen the front screw (Item 1) and remove the rear screw (Item 2) [Figure 50-20-4] and [Figure 50-20-5] from the gas cylinder mounting bracket.

Rotate the mounting bracket forward to relieve any remaining tension on the gas cylinder(s) [Figure 50-20-6].

Remove the front screw (Item 1) [Figure 50-20-6] from the gas cylinder mounting bracket.

Installation: Tighten the screws to 100 – 130 in.-lb. (11,3 – 14,7 Nโ€ขm) torque.

Remove the retaining pin(s) (Item 1) [Figure 50-20-7] and [Figure 50-20-8] from the top pivot pin(s).

Remove the gas cylinder(s) (Item 2) [Figure 50-20-7] and [Figure 50-20-8] from the operator cab.

Reverse the above procedure to install the gas cylinder(s).