Lift and block the loader. (See Procedure on Page 10-10-1.)
Start the engine. Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)
Stop the engine.
Raise the operator cab. (See Raising on Page 10-30-2.)
Drain the hydraulic fluid reservoir [Figure 20-90-1]. (See Removing And Replacing Hydraulic Fluid on Page 10-120-2.)
Mark and disconnect the hoses (Item 1) [Figure 20-90-2] from the hydraulic fluid reservoir.
Remove the hydraulic reservoir bracket (Item 1) by removing the two mounting bolts (Item 2) [Figure 20-90- 3].
Installation: Tighten the mounting bolts to 15 – 20 ft.-lb. (20 – 27 Nโขm) torque.
Remove the reservoir.
