BOBCAT S130 – BOBCAT CONTROLLER (SJC) (DRIVE) – Removal and Installation

Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.)

Raise the operator cab. (See Raising on Page 10-30-2.)

Remove the bolts (Item 1) [Figure 60-72-1] from the controller mounting plate.

Remove the controller (Item 1) [Figure 60-72-2].

Remove the screw (Item 1) [Figure 60-72-3] to remove the wire harness from the controller.

Installation: Tighten the connector screw to 30 – 35 in.-lb. (3,39 – 3,96 Nโ€ขm) torque. DO NOT OVERTIGHTEN!