BobCat E35 – SWING FRAME – Bushing Removal

The following parts will be needed for removal and installation of the swing frame bushings:
1. Bolt – 19 x 153 mm or (3/4 x 6 in) long.
2. Nut – 19 mm or (3/4 in).
3. Washer – 22 mm I.D. x 79 mm O.D. x 10 mm thick or (7/8 I.D. x 3-1/8 O.D. x 3/8 in thick).
4. Washer – 22 mm I.D. x 89 mm O.D. x 10 mm thick or (7/8 I.D. x 3-1/2 O.D. x 3/8 in thick).
5. Washer – 22 mm I.D. 114 mm O.D. x 13 mm thick or (7/8 I.D. x 4-1/2 O.D. x 1/2 in thick).
6. Spacer – 89 mm I.D. x 108 mm O.D. x 38 mm thick or (3-1/2 I.D. x 4-1/4 O.D. x 1-1/2 in thick).

Install the spacer (Item 6) and washer (Item 5) [Figure 40-140-14] over the flanged end of the bushing.
The spacer (Item 6) [Figure 40-140-14] must be centered over the bushing to avoid contact between the bushing and the spacer during removal.
Install the washer (Item 3) [Figure 40-140-14] onto the opposite end of the bushing. This washer must be centered on the bushing and must not contact the casting.
Install the bolt (Item 1) and the nut (Item 2) [Figure 40-140-14] through the washers and the spacer.
Tighten the bolt and nut to remove the bushing from the casting.