Disconnect the negative ( – ) cable from the battery. (See Removal And Installation on Page 50-20-2.)
Remove the plug (Item 1) [Figure 50-150-2].
Remove the screw (Item 1) and knob (Item 2) [Figure 50-150-3].
Remove the nut (Item 1) and bezel (Item 2) [Figure 50-150-4].
Installation: Tighten the nut to 24 Nโขm (18 ft-lb) torque.
Remove the two bolts (Item 1) [Figure 50-150-5].
Remove the bracket (Item 1) [Figure 50-150-6].
Tilt the switch down. Remove the nut (Item 1) and washer from both switch terminals. Remove the cables (Item 2) [Figure 50-150-7] from the switch.
