BobCat E35 – HYDRAULIC CONTROL VALVE – Inlet Valve Section Disassembly And Assembly

Remove the fitting (Item 1) [Figure 20-40-50].

Installation: Tighten the fitting to 28,5 – 30 Nโ€ขm (21 – 22 ft-lb) torque.

Remove the orifice (Item 1). Remove the O-rings (Item 2) and back-up ring (Item 3) [Figure 20-40-51].

Installation: Tighten the orifice to 3 – 3,5 Nโ€ขm (27 – 31 in-lb) torque.

Remove the plug (Item 1) [Figure 20-40-52].

Installation: Tighten the plug to 28,5 – 30 Nโ€ขm (21 – 22 ft-lb) torque.

Remove the O-ring (Item 1) [Figure 20-40-53] from the plug.

Remove the bolts (Item 1) [Figure 20-40-54].

Installation: Tighten the bolts to 9 – 11 Nโ€ขm (6.6 – 8 ft-lb) torque.

Remove the adjuster (Item 1), spring seat (Item 2), spring (Item 3) and spool (Item 4). Remove the O-ring (Item 5) [Figure 20-40-55].