BobCat E35 – FUEL TANK – Removal And Installation (Canopy Equipped Excavator)

Remove the floor mat and center floor plate. (See Removal And Installation on Page 40-110-1.)
Remove the left upperstructure cover. (See Removal And Installation on Page 40-70-1.)

Remove the bolts (Item 1) and plate (Item 2) [Figure 40-120-1].

Disconnect the wire harness (Item 1). Remove the hoses (Item 2) [Figure 40-120-2].

Remove the two hoses (Item 1) [Figure 40-120-3].

Remove the two nuts (Item 1) and bracket (Item 2) [Figure 40-120-4].
Remove the tank.

Remove the floor mat and center floor plate. (See Removal And Installation on Page 40-110-1.)
Remove the left upperstructure cover. (See Removal And Installation on Page 40-70-1.)

Disconnect the wire harness (Item 1) [Figure 40-120-5].

Remove the two hoses (Item 1) [Figure 40-120-6].

Remove the two nuts (Item 1) and bracket (Item 2) [Figure 40-120-7].

Slide the tank out of the side of the excavator and remove the two hoses (Item 1) [Figure 40-120-8].

Remove the tank (Item 1) [Figure 40-120-9].