BobCat E35 – COMPRESSOR – Removal And Installation

Remove the counterweight. (See Removal And Installation on Page 40-90-1.)

Remove the alternator belt. (See Belt Replacement on Page 50-30-1.)

Evacuate the A/C system. (See Reclamation And Charging With Recovery / Charging Unit on Page 71-40-3.)

Cut and remove the cable ties (Item 1) [Figure 71-50-1].

Remove the hose (Item 1) and (Item 2) [Figure 71-50-2].

Installation: Tighten the hose (Item 1) to 28 – 37 Nโ€ขm (21 – 27 ft-lb) torque. Tighten the hose (Item 2)[Figure 71-50-2] to 20 – 27 Nโ€ขm (15 – 20 ft-lb) torque.

Disconnect the wire harness (Item 1) [Figure 71-50-3].

Remove the bolt (Item 1) [Figure 71-50-4].

Remove the two bolts (Item 1) [Figure 71-50-5].

Remove the bolt (Item 1) [Figure 71-50-6].

Remove the compressor.

The compressor is not serviceable and must be replaced as an assembly.