Remove the right console cover. (See Console Cover Removal And Installation on Page 40-50-1.)
Cut and remove the cable tie (Item 1) [Figure 20-170-1].
Disconnect the wire harness (Item 1) [Figure 20-170-2].
Remove the connector lock (Item 1) [Figure 20-170-3] from the connector.
Depress the wire terminal tabs and remove the wires from the back of the electrical connector [Figure 20-170-4].
Installation: Re-bend the tab (Item 1) [Figure 20-170-5] on each wire before installing the electrical connector.
Installation: The wires must be installed in the proper locations in the wire connector, listed below:
A Green
B Brown
C Red
D Black
E White
Check each wire to be certain the tab locks into position.
Cut and remove the cable tie (Item 1) [Figure 20-170-6].
Route the harness (Item 1) [Figure 20-170-7] out through the top of the dust boot.
Loosen the locknut (Item 1) and remove the handle (Item 2) [Figure 20-170-8].
