Stop the engine and open the rear door.
Remove the negative (-) and positive (+) cables from the battery.
Remove the starter mounting bolt (Item 1) and disconnect the ground wire (Item 2) [Figure 60-40-3]
from the starter.
Disconnect the engine harness power wire and positive (+) battery cable starter solenoid terminal (Item 1) [Figure 60-40-4].
Disconnect the tan wire (Item 2) [Figure 60-40-4] from the R terminal on the starter solenoid.
Disconnect the brown wire (Item 3) [Figure 60-40-4] from the S terminal on the starter solenoid.
Remove the mounting bolts (Item 4) [Figure 60-40-4] from the starter.
Remove the starter from the engine.
Installation: Tighten the three mounting bolts to 25-28 ft.-lbs. (34-38 Nm) torque.
Reverse the removal procedure to install the starter.
