Put the linkage end of the spool in the vice [Figure 20-41-73].
Install the spool tool (Item 1) [Figure 20-41-73] over the centering spring.
Remove the bolt (Item 1) [Figure 20-41-74] holding the centering spring to the spool.
Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque.
Remove spring tool from the spring assembly.
NOTE: The centering spring (Item 3) [Figure 20-41-75] is white on all 700 series loaders.
Inspect the adapter (Item 1), collar (Item 2), spring (Item 3) and washer (Item 4) [Figure 20-41-75].
Remove the spool seal (Item 1) and the back-up washer (Item 2) [Figure 20-41-76].
Assembly: Always use a new spool seal.
