Remove the three belt shield clips (Item 1) [Figure 70-90-1] and remove the shield from the drive belt housing.
Loosen and remove the drive belt tensioner (Item 1) [Figure 70-90-2].
Remove the drive belt. (Refer to Contents Page 30-01 for drive belt adjustment procedure.)
Remove the six mounting bolts (Item 1) from the engine flywheel (Item 2) [Figure 70-90-3].
Installation: Apply engine oil to the threads and seats before tightening. Tighten to 72-80 ft.-lbs. (98-108 Nm) torque.
Remove the flywheel from the engine.
Installation: Be sure to align the hole (Item 3) [Figure 70-90-3] in the flywheel with the pin located on the crankshaft.
Reverse the removal procedure to install the flywheel.
