Pull the pin (Item 1) [Figure 50-91-1] holding the foot pedal linkage to the sensor.
Disconnect the two connectors (Item 2) [Figure 50-91-1] from the sensor and lock solenoid.
Tilt the foot pedal up and remove the two nuts (Item 1) [Figure 50-91-2].
Remove the foot pedal and sensor assembly from the loader.
Remove the two bolts (Item 1) [Figure 50-91-3] from the foot sensor shield.
Installation: Tighten the bolts to 80-90 in.-lbs. (9,0-10,2 Nm) torque.
Remove foot lock solenoid (Item 1) [Figure 50-91-4].
Installation: Apply a drop of oil to the solenoid threads and tighten the solenoid to 35-40 ft.-lbs. (47-54 Nm)
lubed torque.
Remove the two bolts (Item 2) [Figure 50-91-4] from the bracket and sensor assembly.
Installation: Tighten the bolts to 25-28 ft.-lbs. (34-38 Nm) torque.
Remove the sensor assembly.
