Remove the handle control unit from the steering lever.
(See Control Handle Removal And Installation on Page 50-111-5.)
To remove the switch handle the connector (Item 1) [Figure 60-120-10] must be removed from the wires, use the following procedure:
Remove the wedge (Item 1) [Figure 60-120-11] from the connector.
Using a pointed tool, press down on the tab (Item 1)
[Figure 60-120-12] and pull the wire from the connector.
Installation: Install the wires into the connector as listed below [Figure 60-120-12]:
Right Steering Lever Switch Handle
1-Terminal – Pink/Red
2-Terminal – Pink/Black
3-Terminal – Pink/Green
Left Steering Lever Switch Handle
1-Terminal – Brown/Red
2-Terminal – Brown/Black
3-Terminal – Brown/Green
Disconnect the right switch handle connectors (Items 1 & 2) [Figure 60-120-13] from the loader wiring harness connectors.
Disconnect the left switch handle connectors (Items 1, 2, 3 & 4) [Figure 60-120-14] from loader wiring harness connectors.
Remove the connector locks and connectors from the wires to remove the switch handle from the steering handle.
Installation: The wire colors of the steering harness are as follows:
Right Switch Handle
Ten-Pin Connector
A-Terminal – Orange
B-Terminal – White
C-Terminal – White/Black
D-Terminal – White/Red
E-Terminal – Green
F-Terminal – White/Green
G-Terminal – Blank
H-Terminal – Lt. Green
J-Terminal – Yellow
K-Terminal – Blank
Three-Pin Connector
A-Terminal – Pink/Red
B-Terminal – Pink/Black
C-Terminal – Pink/Lt. Green
Left Switch Handle
Ten-Pin Connector
A-Terminal – Orange
B-Terminal – Dk. Blue
C-Terminal – White
D-Terminal – Blank
E-Terminal – Blank
F-Terminal – Yellow/Red
G-Terminal – Yellow/Green
H-Terminal – Blank
J-Terminal – Blank
K-Terminal – Blank
Three-Pin Connector
A-Terminal – Brown/Red
B-Terminal – Brown/Black
C-Terminal – Brown/Lt. Green
Two-Pin Connector
A-Terminal – Orange/Blue
B-Terminal – Orange/White
Five-Pin Connector
A-Terminal – Green
B-Terminal – Brown
C-Terminal – Blank
D-Terminal – Yellow
E-Terminal – Blank
Roll the pistol grip handle cover (Item 1) [Figure 60-120-15] down.
Using a small screwdriver, lift the handle tabs (Item 2) [Figure 60-120-15] and slightly rotate the switch handle.
Pull the switch handle and wiring harness assembly (Item 1) [Figure 60-120-16] from the steering lever.
Installation: When installing the switch handle and wiring harness assembly into the steering handle, route the harness (Item 1) [Figure 60-120-17] to assure proper return of the control handle to neutral position.
