Remove the attachment. Tilt the Bob-Tach fully forward until it rests on the floor. Stop the engine. Raise the seat bar. Disconnect the hose (Item…
Use the following tools to disassemble and assemble the cylinder: MEL 1074 – O-ring Seal Hook MEL 1396 – Seal Installtion Tool MEL 1033 –…
1. Tube 2. Case 3. Nut 4. Piston 5. Ring 6. O-Ring 7. Spacer 8. O-Ring 9. Washer 10. Head 11. Seal 12. Seal 13.…
Fully lower the lift arms. Stop the engine. Pull up on the lift arm by-pass control and move the lift pedal to release the hydraulic…
Open the rear door. Remove the bolt (Item 1) [Figure 20-20-1] from the base end pin retainer (left side shown). Use a slide hammer to…
Figure 4-11 illustrates the operation of the radial piston pump. The pump consists of a pintle, which remains stationary and acts as a valve; a…
Many hydraulic applications are similar to Figure 2.16, where a workpiece is held in place by a hydraulic ram. There are essentially two distinct requirements…
In axial piston pumps of the in-line type, where the cylinders and the drive shaft are parallel (fig. 4-13), the reciprocating motion is created by…
referred to as limited rotation cylinders, of the single or multiple, bidirectional piston are used for turning, positioning, steering, opening and closing, swinging, or any…
Another type of axial piston pump, sometimes referred to as an in-line pump, is commonly referred to as a Stratopower pump. This pump is available…