The door can be removed from the cab by slowly swinging the door back and forth while lifting up on the door [Figure 40-30-11]. Installation:…

Build the service lifting bracket used to remove and install the cab. Use the dimensions shown [Figure 40-30-1] to build the service lifting bracket. Remove…

Build the service lifting bracket used to remove and install the ROPS canopy. Use the dimensions shown [Figure 40-20-1] to build the service lifting bracket.…

Rotate the swing bearing so the outside soft zone (Item 1) [Figure 40-10-6] is to the right hand side as shown. Use a tap in…

Lower the blade all the way. Put all the control levers in neutral. Remove the boom. (See Removal And Installation on Page 40-150-1.) Remove the…

If reusing the existing swing bearing, use the alignment marks to put the swing bearing in the correct location. If installing a new swing bearing…

Remove the upperstructure. (See Removal on Page 40-10-1.) Mark the swing bearing to track frame. Remove the 24 bolts (Item 1) [Figure 30-40-1] and nuts…

The following pages show photos and illustrations of track damage and the probable cause of the damage. It is intended to be used for identifying…

Remove the bolts (Item 1) and guide plates (Item 2) [Figure 30-21-43] from the track frame.  

Remove the drive sprocket bolts [Figure 30-21-42]. Installation: Put thread adhesive (Loctite® 242) on the bolts and tighten to 108 N•m (80 ft-lb) torque. Remove…